UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Wow, thank you so much for the info, it was really helpful!
The simple solution ended up being the answer. I ran a home position and then a ABL then the print project and it ran normally.
Thank you so much.
I have an Ender 3V2 with a CR Touch auto-bed leveler. I am trying to upgrade to CURA 5.7 from CURA 5.4. However when a run a project from CURA 5.7 the Auto Bed Level tries to run off the print bed.
Typically the Auto Level starts in the bottom right corner and goes in a 4x4 grid starting right to left.
Now when I run a project in CURA5.7 the auto bed level still starts in the bottom right corner but now tries to travel to the right.
The only change I made was the version of CURA and when I slice and run the print in CURA 5.4 it works fine.
I'm running Marlin and the only thing I do to run the Auto Level is add G29, so I am confused as to why this happens.
Any insight would be greatly appreciated.