Mark3D

I was settings… I pulled the line with down, temp up 5degrees material plus 10% its running smooth. With good quality prints ! thanks all!

It is an Ultimaker 3 I have 3 of those, all more or less the same problem, after trying around I will try to get a different brand of filament …. I spend a lot of time cleaning, and calibrating, and because all 3 printers give(almost) the same result with the same settings, I’m excluding a setting (for now) they all run on the same most recent stable firmware, and have the exact same file, leading to the exact same result, with the exact same material, ordered on the same time, so I’m now going to try to exclude the materials from the problem, to see if it stays consistent ….. thanks for the tips! I let you know when i switched it…

Thanks ! I have been playing around with this setting in a range from 100 to 125 % remarkable difference ! not yet optimized, but at least it is a good start, I am wondering how the line thickness setting is influencing the result? does it have a lot of effect on the result product, or is it just to determine the number of lines in cura? im relatively new to this matter(as you probably noticed..)

Hi, I have got some issues printing cookie cutters, I have openings in my letters which is not what I would like to have, and I can not get it much better , thank you so much for any advice !