Souvik20

@Slashee_the_Cow I have attached the original profile from the manufacturer. I have changed the print speed, wall count, and infill settings from the original file. I'm a newbie, so can you suggest me a way to approach this problem? Thanks. 3D Potter 10 PRO.3mf

@GregValiant You are right. Some materials were sticking to the nozzle and moving around with it during the printing. However, I have used the same material and printed hollow models successfully without any sticking. 1) Is it possible because of an incorrect gap between the first layer and the nozzle for materials to stick like these? 2) Also, during the printing I can see there is no extrusion in the red-marked place for every layer. Can it be due to the slicer settings? Because, if the material is not extrudable then the discontinuity can occur at any random place instead of happening in the same position for each layer.

Hello! I'm currently facing an issue of discontinuous extrusion while I try to print a solid model. When I tried a hollow model with the same material it worked well. For the solid model, I changed the number of walls count from 1 to 0 and then infill from 0 to 100% compared to the original profile for hollow model. From the attached figure, you can see for solid models (red lines in the middle)there is no extrusion. Can you please have a look at my project file and suggest me what would be the best way to solve this issue? Thank you. Solid cube 2in. x 2in..3mf

@Slashee_the_Cow Thank you for the recommendation.

@GregValiant Thank you so much. It worked :).

Hello! I have a problem with the infill settings of a solid cube. I have 0 top and bottom layers, wall counts -0, and infill set at 100%. The infill line directions are [90, 90]. However, I have an issue with the starting position of the infill line. After the first layer, the infill line starts from the middle (orange in the picture) of the print rather than starting from the edge. What can I change so that every infill line in each layer starts from the same position? I have attached my project file. Please give me some suggestions. Thank you. Solid cube.3mf