About This File
Here is a small cloud I sculpted inside ZBrush last week ;)
some informations about the print :
Printer : UM2 + Olsson Block + Bondtech Feeder
Nozzle : 0.6mm
LayerHeight : 200µm
Wall : 3 (1.8mm)
Top/Bottom : 6 layers (1.2mm)
Infill : 15%
Temp : Nozzle -> 200° / Bed -> 60°
Speed : 55mm/s (1st layer at 35mm/s)
Printed with the tip in the air
Supports : 50° / 15% in density
Total printing : almost 1h
Concerning the sanding process, I started with a grain at 180 and then after 400 to finish at 600 (personally I do not go down in grain it's already quite smooth in 600 :)
I also made a Time Lapse of the sculpting