Hi ..
I have equipped my UMO (+HBK) with an v6 Hot-end according to this Description and found a mistake in the original description. There is written hat a 4.7Ohm restore shall be used, but you have to use a 4,7K resistor!
Add-on: I have bought Extrudr Greentec Pro filament to print a mount based on amadee's design as this should be an easy filament with good thermal resistance. But be aware, if the fitting of the hotted is to tight the plastic parts break because of the internal tension. Finally I made it print one's who survived until now, but it was not a easy task.
br J.