Hi all,
Four monthes ago, I purchased a brand new Ultimaker 2 which seemed a reliable machine.
When I've received it, I had many problems to level building plate correctly. Machine was not stable on a flat glass table. Chasis geometry was not correct.
http://vimeo.com/85389366
Ultimaker support proposed me a swap to a brand new machine.
Some weeks later, I've received a brand new machine. But no luck again, this machine had a geometry problem on opposite side. A micro switch was also defective.
http://vimeo.com/88923656
Ultimaker support proposed me again to swap to another machine.
Today I've received a new machine but again a problem with a broken micro switch.
Very bad luck for me...