ignace-de-keyser

My apologies for not answering your question. 1)I was printing at layerheight of 0.1mm at 80mm/s with a shellthickness of 0.8mm. 2)I will update this soon™. 3) Would using a nozzle with a higher width allow to print faster with a shellthickness >0.4mm? 4) I will attempt this test as soon as my current prints finish. Thank you for responding to my questions. with kind regards, Ignace De Keyser EDIT:1mm changed to 0.1mm

I did the test again at 240° and now it only started skipping somewhere between 7 and 8mm³/s

Did the test, feeder starts skipping at 4mm³/s.

Hello, I am having some trouble with printing at normal and higher speeds. When printing at these speeds ( >50mm/s), my feeder will often skip backwards, causing parts of the print to be underextruded. I am using an Ultimaker 2 and using PLA, printing at 230°, the layerheight does not seem to make a difference. If I print at slow speeds, I don't experience any skips. Most of the time I print Jorisstyle, I don't know if it has any influence. I would appreciate your feedback, with kind regards Ignace De Keyser