-
Posts
10 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by Stavros
-
-
Thanks to everyone. I think it was the pressure on the extruder spring
-
I think we have identified that its a problem with the extruder gear. The filament has ground again. I don't think I can actually back off the screw any further. I just started a print and the big gear started slipping! It is currently at 14mm. I think it should be at 11.
-
-
I think your temperatures could be too high - both the extrusion and Bed.
Can you recheck the recommended temp for the PLA you have (I would usually expect 190-210 as the recomended range) - and for the bed try lowering to ~60c
That didn't work. The corners curled up and it still jammed after 6 hours. Here's a pic of the print
-
OK. I will try reducing the temperature on the UMO. I had put the temp up to 220 to try and stop under extrusion.
-
Hey dudes and dudettes.
Every day I get a blocked nozzle. I have even fitted a brand new nozzle but the same thing happens. These are prints I need for work so it's incredibly frustrating.
I have attached a picture of the prints. The Cura settings are a follows, I'm using standard PLA:
Layer H: 0.15 mm
Shell T: 1.2 mm
Bottom/ Top: 1.2 mm
Print Speed: 60 mm/s
Temp: 220c
Bed Temp: 70c
-
I made this guide for myself. I'm not sure if my units are correct, but if they are would you be so kind as to put it somewhere where other people who might need it can go. Thanks.
- 1
-
much obliged
-
Yes. Severe underextrusion. What print speed, temperature and layer height are you using (these are the 3 variables that affect underextrusion - knowing only 2 of them is useless). Here's a chart with suggested print speeds - use half the value of the blue line in the chart for a given temperature (the blue line is absolute maximum):
http://umforum.ultimaker.com/index.php?/topic/4127-um2-extrusion-rates-revisited/
Is this the same for a UMO?
Extruder Pressure on UMO
in UltiMaker 3D printers
Posted · Edited by Guest
I am having trouble with my extruder tension I don't know if its to tight or too loose, but I suspect it is too loose because it's not pushing out the extruder and backing up at the extruder gear (see pic).
Anyone have a link for how to tension it correctly? i.e. a better one than the Assembly guide stating a specific length on the adjustment screw.