VapeLounge

The combination of Cura with all the quality profiles and the UM3 and the Ultimaker materials is thoroughly tested. You will get excellent results in terms of print quality and reliability. Ultimaker sells an open system, and you can choose to use other filaments. No problem with me, but often that means you have to spend time on optimising print settings and dealing with failed prints, because materials from different suppliers have different properties. Ok. Thx so much.

Hello. Do you advise me to use the Ultimaker materials because the machine is set to just go with your own?

Good morning. Thank you all for the advice. As soon as I can do the tests you have advised me and let me know how it went.

My problem coincides with your description.

Sorry, I don't really understand that I should do.

Hello. I did the X/y calibration. The model part is the rear and the right side.

When I remove the print Core 2 I do it when the machine tells me to open the door and remove the print core.

Help please.

Hello guys, you always trouble with my problems, but unfortunately it is only recently that I use the 3D printer. I post these photos to figure out how to fix it. Another thing, when I have to replace the print core 2, often the machine says "contact ultimaker temperature error". thank you all for the support.

Ok fbrc8. Thx soo much.

I'il check the temperature. PVA I keep it in the printer.

Hi, thanks for the answer. I'm printing at 200 degrees Celsius.

I thought you could be pushing wire. I tried to loosen the screw that tensions the spring, let's see what happens!

Now I'm out of the house. Just indented a photo.

Good morning guys. I have a problem with my Ultimaker 3. When I use double extrusion, the second extruder at a certain point of the press does not make the thread exit. I have already done the cleaning of the extruder and checked the wire unit to see if there was any grinding material inside it, it seems OK. I can't figure out what it is, can somebody help me?

Ok guys, I'm doing a print and PVA does his job. I have only one last problem, ie, it happens that the PVA in some parts will break and that it then becomes unstable, can be diburdened by a bad leveling of the plane?

I have done both procedures and now seems to be all OK. When the print is over, I'll let you know how it went. Thanks guys.

Thank you so much Robert. Now I try with your suggestions and let you know.

Hi guys. I have a problem with the second extruder, BB, of my Ultimaker 3. When loading the PVA, the wire pusher does its duty but, when it comes to the extruder, it keeps pushing and does not exit the wire. Who can help me? Thank you.

Ok M8. Thx so much.

I am certain that I would like that.