I have an Ultimaker 2+ for about 2 years. Recently, I can get the printer to feed the PLA material through the hose but only to the nozzle but then it stops. I have cleaned out the nozzle using the atomic method and opened up and cleaned out the feeder. I am able to get the nozzle hot through the "nozzle heatup" command however when I try to put the material through the nozzle is not hot and I am guessing why the material stops there and my material starts to get grounded up my the feeder. I am perplexed to why I can heat up the nozzle when I am not feeding in new material but the nozzle isn't hot when I am attempting to feed in the material. Any ideas or suggestion? Thanks! Dale B