Jump to content
Ultimaker Community of 3D Printing Experts

Pantera09

Member
  • Content Count

    4
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Pantera09

  • Birthday 09/24/1961

Personal Information

  • Country
    US
  • 3D printer
    Ultimaker Original
  1. Greetings, I have replaced the UMO board with a ramps 1.4 and everything is complete with the exception of the hot end thermistor. on the UMO, there are two thermistors both with three wires, but only two are required for the ramps board. So I can either use the orange yellow and brown or the green peach and tan. My question is, what two wires do I use to connect to H1 Therm, in what order and what about the third wire? thank you in advance PANTERA
  2. Greetings, I am having trouble identifying the current path to the extruder motor #1 on the pcb. I burned up the PS when I tripped the circuit, and after running several programs on the mega, uploading the latest Marlin firmware, and reassembly I have found that everything works as normal with the exception of the motor for the filament extrusion (no voltage). I would rather repair the circuit than replace it as I am on a disabled veterans pension. Any input or advice will be very appreciated. thank you in advance, Pantera09
  3. Pantera09

    drifting print

    thank you for responding, the site you directed to me is perfect and exactly what I need. I am positive that I can find answers to my issue here thank you very much. Pantera09
  4. Pantera09

    drifting print

    greetings all, I have recently reconstructed an Ultimaker Original and was printing fine. The other day, during a print the layers started to drift. At first the drifting was +y and of late, was -y. But in each case the layer were accurate but drifting. Any thoughts? I consider myself to be a novice and this is my first printer. Also, the cura software does not communicate with the printer effectively and will not level or run a printer check, and as a result I only print with the SD card. thank you in advance, 09
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!