Its an old thread. But i'd like to share my settings for ultimaker 3 using T-glases (aftermarket)
Filament was 3mm - Cura 5.x - Using glue on glass to make sure the model doesnt move during printing
I pick PETG as original settins / materials:
- density 1.27 g/cm3
- diameter 2.85mm
Print settings:
- Print temperature: 240
- Build plate temperature: 75
- Standby temp: 140
- Retraction distance: 3.5mm
- Retraction speed: 45mm/s
- Fan speed: 10%
Attached is a picture of the printing.
Feel free to comment or give your feedback about it.