Jump to content


New member
  • Content Count

  • Joined

  • Last visited

Everything posted by timoprint

  1. Hello Community, since a long time I am reading in this very helpful forum but now I have to ask for tips and solutions aswell. My inner holes are only poorly connected to the other layers. This happens only to horizontal holes, walls are not affected aswell. At the beginning I had a lot of retraction problems (not enough filament after retraction, 100% filament flow only after some cm) and had to change the retraction distance to only 0.3mm. Not the beginning after traveling is uncomplicated... but the holes still have probelms. https://photos.app.goo.gl/nQr1qtJLsEZDDtuO2 My setup: Cura 3.0.4 and a Anycubic Prusa i3 Any suggestions? Thank You, Tim
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!