[Umo+ esteps too much issues]

So i have been trying to do the esteps for my umo+

 

The initial e-step value is +836.0

 

I asked for 100mm filament in the printer and i got only 45mm !

 

I made the equation and i got 1857.77 as a new value for my esteps wich is too high i think.

 

Now each time i ask the printer to extrude filament, it starts retracting after that....

 

Too much issues in one poeration :)

 

can anyone help?

[UMO+ e-steps]

Hi,
I want to learn how to to do the e-steps for my umo+ but i cant figure out how to extrude filament from Marlin firmware.
Is there a specific firmware version that i should use?
Thanks

[umo+ Isolateur Tube]

Hi,

I have a question about Isolateur Tube that comes by default with the umo+ kit

is it 3mm?

 

Thanks

[UMO+ Shaking]

Actually you were right about the wires and that was the issue, x and y were reversed!
Promblem solved
Thank you verry much for your help!

[UMO+ Shaking]

@JohnInOttawa Thank you for your reply,

Yes the problem is happening at Homing, i did check the limit wires and it looks fine, also the position of the limit switchs them selves theres is like 3 mm ditance between the limit switch and the sliding blocks,but yet it's still chaking becasue somehow when it reaches the limits it doesnt move smothely, i think it has someing to do with X Y axels.

[UMO+ Shaking]

Hi gyus,

I have an issue with My UMO+ that i just assembled, when it reaches the x/y limits  it starts shaking badly,
In consequence some of the bolts are getting loosen up.

Any ideas on how to fix this problem?

 

Thanks