[Cannot load Cura 3.6]

found this via google

Quote

Import problem solved by the following steps:

1. Either edit setup_win32.py and simply change 'Arcus' to arcus or modify the Arcus installation folder to 'Arcus'

 

[Recommended Settings]

When you set the infil density above 0.0%, it opens a new menu 'infill pattern'

[Not slicing all layers]

The object in the stl measures 0.5 x 1.4 x 0.7 mm.  I think this is just too small to get a good slice from.

 

[CURA auto bed level BEFORE heating extruder MACosx]

If you dont put your own M104 S0  M140 S0 right after the G28, cura will will insert them at 1st layer temps.

You will need to put the M104 M140 later in the start codes else cura will not heat the bed/extruder.

 

[How to use printing Temperature Initial layer ?]

M104 S{material_print_temperature_layer_0} ; set extruder temp
M140 S{material_bed_temperature_layer_0} ; set bed temp
M190 S{material_bed_temperature_layer_0} ; wait for bed temp
M109 S{material_print_temperature_layer_0} ; wait for extruder temp
 

[possibility to create different options for the same piece]

Multiple processes would make cura awsome?

[Cura won't accept build volume]

Only way i can reproduce it is when i have 'brim' selected,  turn off brim or reduce its size and it should fit ok.

 

[Cura software skipping layers and printing lines between models]

Turn off 'spiralize outer contours'

[problem with nozzle?]

It is reddened because cura is warning you that a 0.4 layer height is too high for a 0.4 nozzle.

Ideally you should set layer height to about max 90% of nozzle diameter, so try 0.35 layer height.

 

[Can't see bottom of dropdown menu - Make Printable Tool]

.Try auto hide the task bar.

[Under extrusion after every layer change]

Had this problem while printing a 3d plane,  you need to turn the retract at layer change on then cura will use the extra prime setting at layer change(i have mine at 0.1)

[New version of Cura stops printing mid-job]

Repetier host/server works ok

[Printing off the job]

If it is Marlin, you can disable endstop detection by sending a M121,.after you have homed the printer.

re-enable detection with M120

These can be added to cura's start/end gcode.

 

[Printing off the job]

This could also be a problem with spurious interference from the stepper motors being picked up on the endstop wires,

what firmware are you using?

did you upload it to the controller or was it already installed ?

[Cant remember what the setting is called]

I dont think his is in Cura,

In slic3r it is called 'solid layer every'