[E-steps after reset.]

Yes everything back as if it had just come out of the box.

[E-steps after reset.]

Thank you Smithy, I have also tried that but that didn't do the trick either.

[E-steps after reset.]

Hi guys, hoping for a little help. I have an Ultimaker 2 and and Ultimaker 2+ among several others. I wanted to test out some different feeders. I installed Tinkergnomes Firmware to be able to alter the E-steps as each feeder I tried had a different gear ratio. This all worked well except I found the firmware to be too glitchy even after a factory reset before changing the firmware over. Material starting reversing half way through a print. So I decided to switch back to the original feeder and original firmware. Factory reset and installed the original firmware. Now when going through setup the material does not make it from the feeder to the print head, it only gets half way. I tied manually moving the material to the head and testing a print but it is obvious that the E-steps are wrong unless there is something else going on here. Is there a way of resetting the E-steps separately or is a factory reset supposed to do that? This is the same for the 2 and 2+, I have an Extended 2 and Extended 2+ I haven't attempted to put back to factory yet until I succeed with these two first. Any help would be greatly appreciated. 

[Ultimaker 2+ Built plate height issue]

I'm glad your issue is solved too.

[Ultimaker 2+ Built plate height issue]

Thanks for the replies guys. I too thought it may have been the wrong firmware after reading another forum post but that wasn't the issue. The build plate looked like it was trying to move around 4 -5 cm beyond the Nozzle before grinding and moving back down. 

I've managed to getting working again but I think by pure fluke. I reset back to factory settings. Then Removed the printer from Cura and added it back in again. Once that was done I ran the firmware update through Cura. This seems to have done the job. I hope this works for you too Thomaage.

[Ultimaker 2+ Built plate height issue]

I have an issue with the built plate that I just can't solve. On my Ultimaker 2+ when starting a print the built plate goes up but does not stop until it forces itself against the print head. 

I have tried updating firmware and factory reset but nothing has changed. Nothing has been modded or changed on the printer. Can anyone lend a word of advice with their untold wisdom?