This past week, every print with PVA has failed on my Ultimaker 3.
Here is what I have done so far.
1. For example, during print#1 shown below, it stopped extruding PVA (printcore was just going around without PVA extruded).
2. I baked PVA on Ultimaker build plate at 50 degreeC for 2 hours.
3. Hot-pulled the hotend until clean.
4. At the start of print#2, PVA was extruded clean.
5. During print#2, PVA extruded better with no missing gaps, but stopped extruding at nearly the same level as print#1.
6. Feeder's moving back and forth ok. (however PVA at the feeder's been grinding to a varying degree to the point where for a large print it snapped)
7. I've always kept the filaments in a sealed bag with desiccant.
8. I'm using UM filaments.
I'm really hoping that someone can help me out here!
Thanks.