Jump to content
Ultimaker Community of 3D Printing Experts

Splendid_Lt

Member
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. WOW, thank you! I tried this earlier but didn't want to break anything so clearly didn't pull hard enough. Just popped 2 flat head screw drivers behind it and it moved out. Seems to be all in place now. Thank you so much!!!! All good now! Just got to make it print now.... We will pretend I didn't spend 2 hours looking on my floor for another gear..... Side note, you would think they would have made that small gear a bit fatter so it can't be pushed in and stop working, unless there is a reason it should be able to move?
  2. I have a UM2+ (just bought it second hand). I haven't been able to get it to print right yet, but it was at least taking the filament and printing (just not well). Since updating to the 'Tinker-MarlinUltimaker2plus-17.10.1' and me accidentally doing a load filament while the filament was already loaded (lots of fun sounds). I am unable to put filament into the machine. I took the bondtech extruder off to examine and found that the large gear that connects to the stepper motor gear doesn't reach it unless it's pressed against the case of the printer (pictures to explain). So the extruder gear i
×
×
  • Create New...