UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Hallo,
ich habe seit einigen Tage Probleme beim Drucken von Überhängen, siehe Bild.
An meinen Einstellungen in CURA habe ich nichts geändert.
Was ist hier los? Habe ich einen Defekt in der Hardware? Es werden aber keinerlei Fehlermeldungen angezeigt.
Wer kann helfen?
Gruß Markus
Hallo Helmut,
schau dir doch mal den Stecker an, den du in die Buchse am Ultimaker steckst.
Hier können eventuell ein oder mehrere Pins "verbogen" worden sein, als du den Stecker verkehrt herum eingesteckt hast.
Gruß - Markus