Anyone have difficulty printing with TPU via the Ultimaker material station? Background: first print went fine, everything loaded up and the print was successful. I went to print a second time (same thing) and got error 56 - printer feeder filament pickup unsuccessful. note: the filament had retracted back into the material station by the time I started the second print. I tried 3 more times, checking the feeder tension, obstructions etc. Then I ran a small PLA print and it fed no problem...I'm thinking that last meter or so of the TPU filament, because it has been fed through a couple of times, is no good(?). I will try cutting off 2 meters and try again.