Jump to content
Ultimaker Community of 3D Printing Experts


New member
  • Posts

  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

pazz181's Achievements



  1. Hi I am currently printing out face shields and I've come across a problem that I can't seem to resolve I wonder if anybody can point me in the right direction. At the end of each print the filament is fully rejected from the hot end now in most circumstances this would be a good thing however because I'm continually printing having to feed in the filament after every print is becoming a bit tedious after I've done it 90 times. So does anyone know using Cura 4.5 slicer where this setting is in the menu because I cannot find it. This would save me so much time.
  • Create New...