Jump to content
Ultimaker Community of 3D Printing Experts

Ili

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. My setup: Anycubic Mega-S Cura Version: 4.7.1 (have not changed for a while) Did anyone find a solution to this issue? I just had two consecutive prints fail like that. My guess is that its something about Cura because it says the print should take 1h 47min for something I know I printed before (with other settings admittedly, but nothing that should make that big of a difference) that took like 2h 50min. What seems to happen is that Cura is just writing about half of the file, the printer reaches the end saying it's done printing but the end gcodes are
×
×
  • Create New...