I thought I'd come and share I hope a work around if your CURA is crashing at start up on ASUS Ryzen machines at start up of cura.
I decided to install Prusa slicer in hope I could get back to printing and I was hit with an error advising a DDL that gets injected by A-Volute installed in C:\ProgramData\A-Volute.
This is the sonic pad software installed by ASUS and there drivers. What one I can't say without doing some research but I uninstalled and now Cura is working again
All i did was uninstall sonic pad 3 and then launch Cura without rebooting. This now seems to work!
Hoepfully this helps someone!
PC Spec:
AMD Ryzen 9 3950X
Asus ROG Crosshair VIII Hero X570
Corsair Vengeance RGB Pro 64GB
MSI Nvidia RTX 2070 Super
Samsung 970 EVO Plus 500gb NVM - Main
WD Blue 1TB NVM