btm7336

Thanks for the response. Upon closer inspection, it looks like you're right - the chassis has been skewed slightly due to shipping. I guess mine failed the elephant durability test FedEx generously provides. Where do I start to correct this? Note: the printer does sit flat, atop a two inch thick oak table. The inaccuracy only affects the x-y plane. Attached are some shoddy pictures meant to show the inaccuracy, which is much more apparent in person. Thanks again!

The Ultimaker s5 I have at work, which isn't a particularly cheap printer by any means, seems incapable of printing 90° angles. A flat, rectangular component I recently printed came out instead as a parallelogram without a single right angle. It's consistent and the lines are true, the angles are just all wrong. The printer is only a few months old, and I've done no sort of modifications to it other than adding an air manager. Where should I start? Belts? Rods? Thanks.