Jump to content
Ultimaker Community of 3D Printing Experts

badstubby

Member
  • Posts

    2
  • Joined

  • Last visited

badstubby's Achievements

0

Reputation

  1. What the default print settings in Cura?
  2. Howdy All Been printing for awhile now but new to really dealing with print settings in Cura. I am using version 4.8. I have used the suggested settings and profile setups to print my RC Eagle but when switched back to my regular PLA settings then back to the profile for printing my project, I get a shelled version when sliced. Check the attached pic. Top picture is what is should look like but the bottom pic is what I get when sliced. What am I missing? Did I make a setting in an area where not needed by accident or am I missing something simple. Again, I never messed around with settings before so I am learning as I go along. Any suggestions?
×
×
  • Create New...