amb93

Hello, I had the same problem today, I ran the 10-hour print last night and came back this morning with a heart breaking view of my ultimaker 3 on the ground with an error message about the x axis limit switch. Weird enough the spool was like 2 meters away from the printer which made me think about a dog or cat but that was unlikely, I still didn't watch the surveillance footage but there was no signs of forced entry and the door was locked. the last image printer camera should me appeared to be still on the shelf with filament all over the place so maybe there was something wrong with it. I'm still trying to figure out how it tipped, the surface is kinda flat. Luckily, the damage was minimal and there was no clogged filament in the cores , however there is a misalignment in the y axis that makes a noise when moved. I'm trying to align it and see if it works or not. I expect more fault detection from a 3,500$ 3D printer.