Darkstang5887

Just a follow up, after all my testing and following the guide from gr5, I came to the conclusion that my board was bad. Even the olimex cable could not connect to the board. After replacing the olimex board, the printer started up right away. Something happened to the board which I do not know but that was for sure the issue. Hopefully this helps someone in the future with a dead printer.

I received my olimex cable and I'm pretty certain I set everything up right using putty on windows 11. I get no read outs, similar to the no read out when HDMI is connected. I'm thinking the olimex board is dead. I bought this printer becuase I have hear the Ultimaker community is very helpful and engaging, but its been a few weeks and have only one response.

no one?

Also removed the wifi board and still nothing

Hello. Hopefully someone can help me. I bought a used ultimaker 3 about a month ago. I replaced the led light strips as they were turning yellow. Also replaced the front screen due to burn in. All has been well since with many prints successfully. Last night I turned the printer off, and now today it wont turn back on. I checked the following: Made sure all cables were secure Tested power supply for 24v No signs of burn marks on white control board Green led on white board and red led on olimex board come on Tried plugging in a HDMI cable to my TV, nothing Tried making a boot disk per gr5 instructions, nothing Fan comes on for 3 seconds after switching power, but nothing else works, completely dead I just ordered an olimex cable but not confident that will help anything