jsharp113

ahoeben, thanks much for the reply. I've always been a little lazy about this operation, as in getting something that works OK and then living with it for years. I'll make some time to try Octoprint.

I'm in the middle of a double whammy - setting up my first Linux distro (Mint), and setting up Cura 4.13.1. I have a printer I built years ago, essentially a Prusa clone with a Ramps controller running Repetier firmware, which I have added as a non-networked Custom FFF printer. My confusion is, how do I tell Cura how to talk to this thing? It is connected via USB and I've been able connect to it with a Linux version of Repetier Host, but I don't see where in Cura I can enter anything like port ID and baud rate. I get the feeling I've missed something obvious, but I have indeed missed it completely.