Hi All,
I came back from vacation and started having issues with my UMS3.
Cura 5.0 on UMS3
Printing on .01 setting (visual intent)/30% infill
Was much better before vacation.
Manually re-leveled bed and x/y calibration. Will try and re-level again (3rd time using the provided calibration card). Should I continue with the calibration card or just use a sheet of paper? Any suggestions? I have been printing a lot with my resin printer, but I am a novice with FDM. I have just seen the issue in the last week and was thinking the cabinet was not stable enough?
Thanks, in advance....