Jump to content

Help? FDM Novice on UMS3 print quality changes.

DevGuyRob

By DevGuyRob
in Improve your 3D prints

 Share

Recommended Posts

DevGuyRob

DevGuyRob 0

Posted
Posted · Help? FDM Novice on UMS3 print quality changes.

Hi All,

 

I came back from vacation and started having issues with my UMS3.

Cura 5.0 on UMS3

Printing on .01 setting (visual intent)/30% infill

 

Was much better before vacation.

 

Manually re-leveled bed and x/y calibration. Will try and re-level again (3rd time using the provided calibration card). Should I continue with the calibration card or just use a sheet of paper? Any suggestions? I have been printing a lot with my resin printer, but I am a novice with FDM. I have just seen the issue in the last week and was thinking the cabinet was not stable enough? 

 

Thanks, in advance....

 

x cube.jpg

y cube.jpg

z cube.jpg

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.4 stable released

        UltiMaker Cura 5.4 stable released

        ArunC posted a topic in UltiMaker Cura,

        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...