Dear all,
I've been trying to print with DSM Arnitel 2045 on my UM3E however I've not had any success. I'm using dual extrusion with the other material being PLA. After a couple of layers the Arnitel under-extrudes because the material which is pretty soft (Shore hardness D34) is coiling and being ground in the feeder. Has anyone of you had success printing it, and if so, do you have any recommendations regarding the settings?
Stuff that I've tried:
Using the material profile from the Ultimaker marketplace as-is
Using the material profile from the Ultimaker marketplace and changing some of the options, e.g. reducing the print speed from 25 mm/s to 20 mm/s, switching off retraction, or changing temperatures
Printing a test cube just with Arnitel, i.e. without dual extrusion (no success either)
Drying the material for 12h at 55°C before printing
Thank you in advance for any help.
Best wishes
Henning