JPCustomPrints

Thank you very much! I didn't notice that the wall ordering was different on cura 5. Again, thank you very much! ^_^

hello there! i'm having a little trouble with cura 5.0. i'm printing a ring part for a keychain. i've been printing this for a while now using cura 4.13. today i used cura 5.0 and this is what i got.. i think it under-extrudes when it starts the layer. i checked in cura preview and the spot where there are under extrusions are spots where the layer starts. I'm using the same profile on both slicer. (on the second pic, the left one is the one sliced using 4.13 and the 2 on the right are the ones sliced using 5.0)