AndreaS73

I'm struggling with ABS printing. I guess one of the variables is the build plate temperature, set to 100 °C. I noticed that after some layers it drops down to 86 °C and then the piece detaches. I'm using a Dremel 3D45 with their "purple" glue. I didn't find the settings where is defined the behavior of this temperature dropping. I enabled the visualization of the all settings, but still I don't find anything related. Would you please help me to find out this setting?

I'm trying to test bridging. I'm reading the docs about Walls and Top/Bottom but still I don't understand why it tries to use a concentric patterns even if I set them to lines. As far as I know you cannot make bridges in that way. Am I wrong? Which setting should I change?