YenJiWai

EZ_8层08间距.gcodehow can I eliminate the blue travel lines so that the next level can start directly from where the last level ends? tkx a lot. the c4d design is as followed

In my windows 10 PC, cura version 5.2.1, the printing route is what I need ,like picture 2. While in my wimdows 11 laptop (version5.3.0), the printing route becomes like picture 1. Since my printing machine has no retraction function, it causes waste of material and unacceptable quality. Pls nicely check my file and see what is wrong. P.S. I need to not tick the ‘origin at center’ option in the machine settings. And I need the route to start from the edge instead of in the middle in each level. EZ_10层圆.3mf

my extrusion is powered by pressured air, so it is continueous and connot stop. the model is a cylinder and a porous scaffold in the picture is what I need. so the blue line of retraction affects the quality. I already tried combing mode. tks EZ_圆柱.3mf

since my machine has no retraction function,this blue line does affect my printing quality

2层间隔24.stl

EZ_2层间隔24.gcode

EZ_2层间隔24.3mf

it always start from the middle

Thank you, I found it when I viewed 'all'.Now I can print the cube correctly. My first problem is solved too.

thank you, I tried printing a cube, but the bottom still exists even though I set 'no bottom'. the infill lines start from the 3rd layer

i created a model as a bioactive scaffold, but i can only print the first 2 layers correctly. the lines start to go wrong from the 3rd layer