dfaulkner85

Where can I purchase only a S5 print head circuit board?

I found damage on the printer head circuit board. I am going to replace this and hopefully this will solve some of the issues. It looks like the screw was not aligned properly with the hole when they attempted to insert it. I highly agree that it is easy to damage all of the parts due to the S5's construction.. Some designs are great like removing the cross rods and others are very poor such as this part. Do anyone know where I can purchase just the circuit board?

Thank you for the response. I checked the level sensor cable and noticed the wire had a slight "pinch". I replaced the sensor and it worked immediately. The noise level went from 30-80 down to 6. Now after 2 prints it is acting up again without making any adjustments, changing cores, or touching the printer other than removing the two prints. The noise level is 30-40. The front axial fan is making a high pitched noise so I am going to replace that now. Is this unreliability normal?

I've been very disappointed and frustrated with my Ultimaker S5. Every time I go to print there is always an error from bed level sensor, offset probe failure, to height of print cores. Can someone explain why I am experiencing all of these issues and how to fix it or is it better to throw this printer out and buy a different brand?

Thank you ! It was the 22mm offset. When I updated the firmware it reset to 0.0 for some reason.

When I perform a calibration my X and Y offset is perfect at 0 and 0. When I go to print my primary core prints perfect however my support core is shifted to one side about 7/8". Any thoughts on what is going on?