[First pass of bridging always droops badly, but second pass is near perfect.]

Bridge settings: https://imgur.com/BiVzTyq
Line: https://imgur.com/a/R89Ucs8  
Flow: https://imgur.com/a/hnTvKgI  
Speed: https://imgur.com/a/o5JY6x2

[First pass of bridging always droops badly, but second pass is near perfect.]

Printer: Ultimaker S5
Material: Ultimaker tough PLA
Firmware: 7.1.3.0

The first strand of a bridge always has very bad drooping, but the second strand is near perfect, lost on which setting to adjust.

 

Using Cura slicer with experimental bridge settings enabled. Tried lower temps, lowering speed, and lowering flow rate. All seems to only apply to the strands after the first, leaving a single strand drooping from what is otherwise a very decent bridge.

[First pass of bridging always droops badly, but second pass is near perfect.]

Printer: Ultimaker S5
Material: Ultimaker tough PLA
Firmware: 7.1.3.0

The first strand of a bridge always has very bad drooping, but the second strand is near perfect, lost on which setting to adjust.

Using Cura slicer with experimental bridge settings enabled. Tried lower temps, lowering speed, and lowering flow rate. All seems to only apply to the strands after the first, leaving a single strand drooping from what is otherwise a very decent bridge.

[Touchscreen not registering touch after firmware update to 7.1.3]

I was performing some routine maintenance and saw there was a firmware update. Updated and now the touchscreen is not responding to touch at all. I've power cycled the entire system multiple time and still can't get it to work.