Hello,
My question is simple actually, i just want to stop the table/bed in the middle of printer.
Let's say u sent a job to the printer and it finished, bed goes downwards and stops at the bottom.
I don't want it to go all the way down. I want to set a Z coordinate manually so, when the job is done table stops there.
I did try few things, like trying to add custom "End G-code" and sometimes it works, table stops exactly where i want it to be but eventually it goes down again no matter what.
I know that, it needs to check where the table is with the switch at the bottom but it needs to do this in the beginning, not in the end.
So, basically i want my printer to be able to stop in the Z coordinate which i will call... and it will stand there until i send a new job.
I would be appriciated if you can share any idea/knowledge with me.
Have a wonderful day!