Tschintna

I'll try to make some screenshots in near future, thanks one single curve is always the pleasanter noise than a lot a circles with travels what I mean is the difference of 'constant driving' towards 'stop and go' - my printer doesn't make bad noise, all fine 🙂 also the new support needs to do a lot more retractions - that's bad for some filaments and needs a lot of time on bigger prints (tree's >10-20cm high) there is a big loss in stability combare to the old tree support I tried different settings and 'Prefered Branch Angle' helped to reduce to number of single trees without a high Z-Hop I had some fallen trees in my tests (Nozzle touched the curled part of the tree 5 times - the old tree didn't care as it was high stable) also I'll test to change the diameters - just I can't imagine to get back the one-piece-bottom

I saw a little benefit if only small areas need to be supported but in my case the new tree needs more time and more filament :-( and also it's much louder to print as this high amount of circles and travels is louder (and/or the noise is objectionable) than the old smooth curves all around to have "prefered angle" and "max angle" now is nice, wish to have that in old tree support also