javaleraj

Hello, first of all, thanks for the answer. During these days I've tried to check everything. The front fan works properly.I also tried using an old print core but the problem is even worse. About the cold pull, I will try to do it again and post a picture as soon as it gets jammed. I also cleaned the feeder but everything looks the same. Do you think the problem could be there? Maybe the gears are a bit worn out and need change(?).Is there a way to check if the feeder is working properly?

Hello, I am doing a project using an Ultimaker S5. The problem comes when at the end of each print, the extruder jams and the next piece does not print correctly. Once I clean the extruder I can continue printing correctly, but at the end the problem returns. I am using a brand new 0.4 mm print core AA and the material is PLA from a manufacturer that I have used before without any problems, both on this printer and others. I have thoroughly serviced all parts of the printer and tried various settings in CURA but the problem persists. Any idea where the problem may be coming from and how to fix it?

Buenas tardes, estoy realizando un proyecto usando un Ultimaker S5. El problema viene cuando al finalizar cada impresión, el extrusor se atasca y la siguiente pieza no imprime correctamente. Una vez limpio el extrusor puedo continuar imprimiendo correctamente, pero al finalizar el problema vuelve. Estoy usando un print core AA de 0.4 mm totalmente nuevo y el material es PLA de un fabricante que ya he usado anteriormente sin ningún problema, tanto en esta impresora como en otras. He realizado un mantenimiento a fondo de todas las partes de la impresora y he probado varias configuraciones en CURA pero el problema persiste. ¿Alguna idea de donde puede venir el problema y como solucionarlo?