Jump to content

BZ_3DPrinter

Member
 View Profile  See their activity

  • Posts

    4

  • Joined

  • Last visited

Personal Information

  • 3D printer
    Ultimaker S5

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

BZ_3DPrinter's Achievements

1

Reputation

1

Community Answers

  1. BZ_3DPrinter
    Thank you very much! Problem found! The filament was ground down by the feeder as photos showed. That causes the problem. Now it prints.
  2. BZ_3DPrinter
    Hi gr5, Thanks for the detailed answers. 1) No successful printing so far. 2) I have a S5 stand-alone. 3) I tried your suggestion after hot and cold pulls, unfortunately no extrusion. 4) I have attached some photos as a result of the cold pull, maybe you will know more after checking this? 5) I am 100% sure I put the lever down. But I think maybe there is not enough force to push the PLA to extrusion? 6) In the first post I already tried two cores. Same problem. Any ideas on how to proceed?
  3. BZ_3DPrinter
    Sorry. My bad. It's 210 °C.
  4. BZ_3DPrinter started following Print core no extrusion during the print.
  5. BZ_3DPrinter
    Newly purchased Ultimaker S5, after loading material there is no extrusion during 3D printing. Material Ultimaker PLA white The temperature is 110C. The fan is working. Feeder tension is centered. Replaced print core, same problem. What could be the problem?
×
×
  • Create New...