good idea, i did think about that when i was doing it but the print is quite specific, but, i did think of a solution kind of, i dont mind swapping the filament twice per layer as it literally is going to be 2 layers, and if you are curious i am modeling a kill medal from halo.
you can see what i meant, by literally only like 2 layers, and also this is what i have made
so its hard to tell but its a few layer set down, so you get the reason why i want the outside one colour and the inside another, but i was thinking, if i wanted to i could slow the print down and then pause swap, and like i said i only have to do this like 2 times so i think it will be fine just slowing it down, or making it larger.