ejbommer

100% correct, but I cant help myself. Damaged DNA I guess.

Think I figured it out, my thermistor is reading low. I tried serval speed settings today and only seen minor improvement. So I finally pulled my fans off and stuck a thermal couple onto the nozzle and set the temperature to 245 Deg C. The nozzle seems like the hottest point and I am reading about 30 Deg C low. So I need to verify I am running the correct temperature curve. I converted to Klipper a few months ago. I keep thinking it used to perform better, but I don't trust mt memory like I used too:) Also figured out how you got the speed values. Thanks again.

Thanks for the explanation. I see the travel speed is set to 250 mm/S. Ill try to slow that way down and see what happens(Maybe 80mm/S) and try to find a better value. Curious what command are you looking at to get this information. Thanks again for the advice.

CE7_BoxV4.gcodeHere it is, thanks

I have an ender 7, printing Overture PRTG. My issue is during the infill print I can hear my extruder is skipping. I have tried to lower the infill print speed setting significantly, but it doesn't seem to make much difference. When printing wall and such, I hear no skipping even though I have print speeds around 70 mm/S I have Klipper installed and on the status display I see print speeds up to 100 mm/S when the setting of infill is 25mm/S. I also watch the gCode viewer and it seems to match 100% during the infill printing I can hear the clicks. Any suggestion on how to lower the infill speed are greatly appreciated. Thanks