Nils_007

Hi @Torgeir, I have a other print. I don’t know why its good at first and bad later in the print. Nils

Hi @Torgeir, today the new pla came. The print looks not good. Nils

Hi @Torgeir The test was good, there was no problem. The pla was dried at 55 deg. for 3 hours. I will test it friday with new pla. I bought new pla yesterday it will be here by friday. Nils

Hi @Torgeir The first layer with dry pla. Now the print is finished and it looks like this. Should i change the heater cartridge ?

Hi @Torgeir The first layer with dry pla. It is not the Pla. Maybe the material pusher is broken? Nils

Hi @Torgeir this should be the right. But i will try to get the pla dry and lower the degre. Thank you for the help i will write of the printer is printing normal again. Now i will dry it and make a test print. Nils

UM2_3DBenchy.3mf

Hi, this is the file. I hope this is helping. I use Cura 5.6 . Regards Nils

UM2_3DBenchy.ufp

Hi @Torgeir It started with a bad surface and then it got worse. I am printing with 225 degree and 100% pla feed. I will share the file tomorrow. Do you think it could be the heater? The prints stick but sometimes they don’t. But Most of the time they stick. Regards Nils

Hello, i have a problem with my Ultimaker 2. The Problem is he is printing verry strange, i replaced the temp. sensor and the problem is still the same. Can anybody please help me? The second picture is the first layer. It is very strange that he prints better in the upper part (picture 1)

Ich hatte die Fehlermeldung „ Error- Stopped Heater error.“ Ich habe das Teil ausgetauscht, jetzt kommt die Fehlermeldung nicht mehr, aber der Drucker druckt immer noch so wie davor. Woran liegt das?

The sensor was black and the metal endcap came of.

Today I disesambeld the printer I have the cabel but i don’t have the end of it it Looks like this. Is this the right one?

I did what you said but now its not working. It now shows this