UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Posted
· Bed does not find Z-axis home position anymore
Hi,
and welcome to the forum.
When does the bed not stop any more? When it goes up or when it goes down?
When you first start a print, the bed tries to go down first. There it hits the limit switch - it does a kind of bounce movement, first triggering the limit switch and then going a bit up and down again. Then it waits for the nozzle to heat up. After that, it goes up and stops a few cm before the nozzle. There it waits until the nozzle starts extruding some filament and then the print starts and the bed goes all the way up to the nozzle.
Where does it exactly fail?
If it is the first - when it goes down, then most likely the mechanical limit switch at the bottom might be dislocated or the switch's arm bent so the screw underneath the bed does not touch it when it reaches the bottom.
When it is at the top and the bed tries to go higher, then you might have flashed the wrong firmware. If you have an Ultimaker 2 and would flash the Ultimaker 2 Extended firmware, then the printer thinks it is taller, and would try to move the bed further up.
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
Nicolinux 288
Hi,
and welcome to the forum.
When does the bed not stop any more? When it goes up or when it goes down?
When you first start a print, the bed tries to go down first. There it hits the limit switch - it does a kind of bounce movement, first triggering the limit switch and then going a bit up and down again. Then it waits for the nozzle to heat up. After that, it goes up and stops a few cm before the nozzle. There it waits until the nozzle starts extruding some filament and then the print starts and the bed goes all the way up to the nozzle.
Where does it exactly fail?
If it is the first - when it goes down, then most likely the mechanical limit switch at the bottom might be dislocated or the switch's arm bent so the screw underneath the bed does not touch it when it reaches the bottom.
When it is at the top and the bed tries to go higher, then you might have flashed the wrong firmware. If you have an Ultimaker 2 and would flash the Ultimaker 2 Extended firmware, then the printer thinks it is taller, and would try to move the bed further up.
Link to post
Share on other sites