Bowden tube

[stevie.d 0]

Hi ,I'm in the middle of building my printer and I'm stuck on the bowden tube feeder, in on the wiki it refers to a teflon tube that the bowden tube fits into,http://www.flickr.com/photos/ultimaker/8185558850/lightbox/ , all I have is this guy, which I am presuming goes on top of the head, so is it the case that this part is obsolete and the intention is for the bowden to feed directly into the PEEK as shown , or, have I been left short this teflon tube??

[Daid 306]

You are missing this part:

http://www.flickr.com/photos/ultimaker/8185558850/

It's VERY important, the setup you show on the photo will cause jams.

[stevie.d 0]

Thanks so much for your quick response ,guess I'm not printing this week then :(