SuperBoppy

[SuperBoppy 0]

Using CURA 5.5. Getting a error loading an STL. I used this exact STL several months ago with no problems. Now, getting sporadic errors when attempting to load or slice. Doesn't happen all the time. No "red spots" in x-ray. Loaded STL into 3D Builder - no errors reported. Mesh tools reports STL to be watertight. I especially get problems if I try to multiply the STL, then re-slice - get slicing errors, sporadically again.

 

I tried using V5.4, and was getting errors, so I don't think it's the new version of CURA.

FINAL_Keychain_Rooted_Logo.stl

Edited November 8, 2023 by SuperBoppy
More checking into problem.

[Cuq 206]

No  issue  to slice this model (In 5.5 ):

 

But an error on some triangles.

[SuperBoppy 0]

Thanks. 

Edited November 22, 2023 by SuperBoppy