Jump to content

ralph80

Dormant
 View Profile  See their activity

  • Posts

    19

  • Joined

  • Last visited

 Content Type 

Posts posted by ralph80

    UMO + won't start after firmware update

    in UltiMaker Cura

    Posted

    I have a ulticontroller that sometimes goes off, I wiggle the cables and goes on. I did disassemble it couple times but I was never able yo fix it. Also once I got a total lost of control and screen went blue and all temps where reset yo 0 (was very annoying) for this problem the solution for me was to isolate the screen cables from the rest of the cables as much as possible (possibly was cable crosstalking). Anyhow, try to check like @amedee says. If that isn't the issue, try to rearrange the screen cables out of the rest of the cables as much as possible. And ofc, try to check that the cables are fully plugged!

     

    Hey Neotko, thank you for your reaction. I took apart the controller en double checked everything. As far as i can see everything is connected in the right way. You where saying that you had a blue screen an 0 temp. My does the same, but it also doesn't react to anything and this happend after the firmware update. How did you isolate the wires? I can always try

    UMO + won't start after firmware update

    in UltiMaker Cura

    Posted

    This is typically what happens when you flash an UMO firmware on an UMO+ (or the opposite).

    Can you tell us exactly what board version is in your printer and which firmware did you flash?

     

    Thank you guys for the reply. Unfortenatly i do not now which firmware it was. I now have the latest firmware one it. The version of the board is 1.5.7.

    UMO + won't start after firmware update

    in UltiMaker Cura

    Posted

    Hello,

    It has been a while sinds iv'e been printing. I installed the latest version of cura 2.3 and ran all the tests. My UMO works perfectly. I thought lets do a firmware update. After the update the controller has a blank screen and the UMO won't start or heat up anymore. I have tried to use older versions of cura but noothing seems to work. Has anyone else had the same problem or maybe a solution for this problem? I hope you guys can help

    Thanks

    eindstop z-as heated bed upgrade

    in Nederlands

    Posted

    Vandaag heb ik eindelijk de nieuwe heated bed upgrade voor de original binnen gekregen. Een paar uurtjes verder en ik had deze erop, wat gelukkig vrij makkelijk ging. Nu kwam ik erachter dat bij het afstellen van de upgrade er onder geen palletje zit voor de eindstop voor de z as. Is dit bewust gedaan of een foutje??

    Wat mij verder opviel is dat bij het levellen van het bed het bed niet meeverwarmd wordt. Hierdoor blijft je testprint niet op de glasplaat liggen en moet je deze dus handmatig voor verwarmen. Is dir eventueel aan te passen in een nieuwere versie van Cura Daid?

     

    SD card

    in Coffee corner

    Posted

    Hello guys, i run in to a problem and i'am hoping that somebody can help me with this. When i insert my sd card the UM controller doesn't find it. This is the first i used it because normally i work with the usb cable

     

×
×
  • Create New...