I have a 2 month old UM2 that has been going downhill slowly. I was at the end of a 4 hour print when one of the belts slipped and the hot end began spilling PLA over the side of the build plate and smashing into the side. I aborted the print and scraped up the PLA. (I am not using any adhesive). When I went to print again, the heated build plate would not heat up. Should I assume it's fried or is there a connection I can check somewhere? I took the electronics cover off, but none of the wires were detached. Neither were any of the wires at the rear of the platform detached. Now I have no heated bed and a cracked plastic bearing block. I submitted a 'support' ticket but have not heard back anything yet. Does anyone have any ideas? I would even settle for installing the parts myself if I knew where to find them.