ivan-lipunov

Great! Feed screws and accurate adjustment of the straps helped! Thanks again for the link!

It pleases. In this case, which of the variants with two nozzles most friendly to newcomers and has detailed instructions for installation and maintenance? Despite the fact that the feature is experimental, I want to be able to print, for example, PLA and nylon without changing the filament every time

Due to the fact that they abandoned this idea does it make sense to look for third party solutions? After reading threads the last few days, I got the impression that to achieve an acceptable result for the average user is quite a difficult task. How great is the risk to turn the printer into a dead brick?

Hi, Didier! Thank you so much for the link to this detailed manual. To test the idea with insufficient degree of fixation of the pulleys on the guides I can, unfortunately, only tomorrow. Let's hope that this will be enough to solve the problem.

Hi, folks! Yesterday we got our new Ultimaker 2. The calibration was successful, a flash card was copied file, and started printing. But after 20 minutes of operation printhead suddenly shifted along one of the axes is more than 20 millimeters, and eventually display a message about a problem with one of the axes. I saw a thread on the forum with a similar problem, but the difference is that no modifications printer in our case were not carried. Visually no damage is observed, reset to factory settings and firmware upgrade to the latest version gave no results. The impression that the stepping motor above the feeder operates in one direction only.Are there any ideas on how you can quickly fix this bug?