Jump to content

Stardust70

Member
  • Content Count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral

Personal Information

  • Country
    BE
  1. I was printing some parts in surface mode. In 2.4 no problems, In cura 2.5 it doesn't slice, no error but print time 0 minutes. The settings are imported from cura 2.4 where they worked. Even if I reset the settings, and choose surface mode, the problem stays.
  2. Tried al settings of losing brim/raft/skirt in cura 2.3 didn't succeed to print larger then 19*19. Tried cura 2.4 set build plate adhesion to none, no problem in printing 20*20 thnx.
  3. The max build volume I'm getting after these instructions, is only 190*190*??? Not the full bed. I'm trying to print a 200*200*55
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!